At the Bredo Shipyard in Bremerhaven, a 43-year-old man was seriously injured in a fall on the 'Elbe 3' on the morning of April 22, 2024, which was docked in the fishing port. The worker fell five meters onto the upper deck of the ship for reasons that wree still unclear. The victim received medical care at the scene of the accident. He was then transported to the ground using a rescue basket and a crane from the local company. Height rescuers from the fire department were also on duty. The man was taken to a hospital.
News
JOANNE MARIE
The National Transportation Safety Board (NTSB) has released an investigation report on April 8, 2024, on the flooding and partial sinking of the 'Joanne Marie' on June 25, 2023, in New Orleans, Louisiana, which was found partially submerged while moored at a shipyard on the Harvey Canal at6 a.m. There were no crewmembers or shipyard workers on board the vessel. An estimated 10 gallons of diesel fuel were released into the water. Damage to the vessel was $176,751. Analysis After the vessel was refloated, no water ingress into any vessel spaces was found, indicating the hull condition did not contribute to the flooding. Postcasualty testing found that, when water was pumped into the through-hull pipe for the propulsion shaft seals’ cofferdam overboard discharge, it entered the cofferdam, which was open to the engine room. The shaft seal cofferdam discharge system had two bilge pumps whose discharges combined into a single overboard line. The discharge lines had valves installed to prevent water ingress. After the casualty, investigators found that a wire nut had lodged in a spring-loaded check valve on the starboard-side bilge pump discharge line, obstructing the valve and forcing it to remain partially open (the swing-type check valve on the portside bilge pump worked properly). Investigators could not determine how the wire nut had entered the cofferdam. The wire nut may have been inadvertently dropped or fallen into the cofferdam when the deck plate covering the cofferdam was removed for regular maintenance. The Coast Guard and company representatives found that the wire nut was small enough to pass through the cofferdam bilge pump inlet strainer, so when the cofferdam bilge pump activated, the wire nut was pulled through the strainer and subsequently the pump impeller and discharge line before reaching the spring-loaded check valve. The spring-loaded design of the check valve held the wire nut in place, leaving the valve in a partially open position and susceptible to backflow. The National Transportation Safety Board determines that the probable cause of the flooding and partial sinking of the 'Joanne Marie' was the ingress of water into the engine room through a through-hull pipe located near the waterline due to an obstructed spring-loaded check valve on a cofferdam bilge pump discharge. Contributing to the sinking were inadequate procedures for securing unattended vessels. Full report: https://safety4sea.com/wp-content/uploads/2024/04/NTSB-Partial-skinking-of-towing-vessel-Joanne-Marie-2024_04.pdf
Istanbul
There is currently limited supply of marine gasoil at the Turkish port of Istanbul, sources said Friday, August 2, owing to limited cargo deliveries in the region.
Portsmouth
Portsmouth International Port is set to welcome 150,000 cruise passengers each year following the completion of its multimillion-pound berth extension project, which has just been started in collaboration with construction firm Knights Brown. The renovation will include levelling out the cruise berth and building an additional dolphin. As a result, ships up to 255 metres in length will be able to safely and conveniently berth at the port.
BRESSAY-BANK PAIR TR
The 'Bressay Bank' berthed at the Mains Pier in Lerwick on the afternoon of April 23, 2024, where a crew member received medical attention. The Shetland Coastguard had received a call just after 11 a.m. to assist with the vessel which was berthing there. A crew member disembarked from the vessel and was awaited by Lerwick’s coastal rescue team and the ambulance service. The ship then left the port again en route to Hanstholm with an ETA as of April 25. Report with photo: https://www.shetlandtimes.co.uk/2024/04/24/emergency-services-attend-medical-evacuation-of-french-vessel
DALI
Officials in Baltimore were plannning to open a deeper channel for commercial ships to enter and leave the city’s port starting on April 25. This would be a significant step toward reopening the major maritime shipping hub that has remained closed to most traffic since the Francis Scott Key Bridge collapsed last month. The new channel will be 12 meters deep, which is a substantial increase over the three other temporary channels established in recent weeks. It puts the cleanup effort slightly ahead of schedule, as officials previously had hoped to open a channel of that depth by the end of April.
Chittagong
It was very easy to see the expected all the vessel in old version. But in new vision, it's seemingly useless. We hope you'll advise us & take necessary steps so that we could take the previous taste in vessel tracker. Thank you.
Turku
Finnish shipbuilder Meyer Turku has cut the first piece of steel for Costa Cruises’ second LNG-powered ship, which will be named Costa Toscana and be delivered in October 2021. Using its new plasma cutter line, Meyer Turku marked the start of the ship production project during a traditional ceremony at its yard in Turku. Once complete, Costa Toscana will have dual-fuel hybrid engines and onboard LNG tanks to enable her to operate using LNG in port and at sea.
CAPE CORDELL
scrapped at Fortuna,Canada 04/2024 https://www.facebook.com/photo/?fbid=336461709446582&set=pcb.336461746113245
ABDULLAH
Unloading of cargo from the 'Abdullah' at the port of Al Hamriyah started on April 23 at 12 a.mn., two hours after the ship berthed at the jetty. Meanwhile, all 23 crew members have decided to come back home on the same ship, according to the ship’s owning firm SR Shipping Ltd, a subsidiary of KSRM Group. Earlier, two out of 23 crew members wanted to sign off from the vessel at the UAE port and return home by air.
Larnaca
The joint venture of Kition Ocean Holdings has submitted its proposal for the development of the existing Larnaca port and marina. After lengthy negotiations with the government, the Cypriot and Israeli joint venture of Kition Ocean Holdings submitted an updated proposal for the far-reaching utilisation and development of the Larnaca port and marina, it said. The company proposes the ultramodern upgrading and expansion of Larnaca port in order to become a pole of attraction for new companies operating in the fields of commercial cruises, transport and energy.
Manila
International Container Terminal Services, Inc. (ICTSI) recently took delivery of another new quay crane (QC) and eight new hybrid rubber-tired gantries (RTGs) for its flagship Manila International Container Terminal (MICT), establishing the terminal as having the largest fleet of modern container-handling equipment in the Philippines with 18 QCs and 58 RTGs. Manufactured by Shanghai Zhenhua Heavy Industry Co. Ltd. (ZPMC), the QC is part of the five from ICTSI’s 2018 USD80-million capacity improvement program package. With a reach of up to 16 rows across twin, the new QC can service the largest feeder vessels calling the Philippines. It will be deployed at Berth 3.